Home > Knowledge > Content
Ten precautions for using the dryer(1)
- Feb 14, 2019 -

1. Do not put in the sun, rain, wind or relative humidity is greater than 85% of the place.

Do not place in an environment with excessive dust, corrosive or flammable gases.

Do not place it  in a place where there is vibration or condensation.

Do not be closed to the wall, in order to avoid poor ventilation.

If must be use in an environment with corrosive gas, and a desiccator with a copper tube or a stainless steel heat exchanger type dryer should be used. It should be used at ambient temperature below 40 ℃.

2. Make sure compressed air inlet is connected correctly. In order to repair, a bypass line should be provided to ensure maintenance space. It is necessary to prevent the vibration of the air compressor from being transmitted to the dryer. The piping weight should not be added directly to the dryer.

3. Do not stand up the drain pipe, do not fold or crush.

4.The supply voltage allows fluctuations of less than ±10%. A properly designed leakage circuit breaker should be provided. Must be grounded before use.

5.The temperature of the compressed air inlet is more than high. The ambient temperature is more than high,when the flow rate receeds the rated process air volume, the voltage fluctuation exceeds ±10%, the ventilation is too bad (the air is also ventilated in  winter ,otherwise the room temperature will rise),the protection circuit will function, the indicator light will  be off, and the operation will stop.

 

 

If you want to know more about Air Compressor or Screw Air Compressor Parts, welcome to scan http://www.qdfutai.cn or contact me on Qingdaofutai@qdfutai.cn